ELECTRIC UNDERFLOOR HEATING: FOUR SOLUTIONS TO MEET EVERY NEED.
Do you know the differences between the different types of electric underfloor heating?
As a manufacturer, we have the widest range of solutions on the market for electric underfloor heating. We carry out personalised studies, providing recommendations for the product best suited to each project.
Get to know the different products and download the product sheets for each product.
- HEATING CABLE
Recommended for both renovations and new construction. It is the most versatile of the four systems. It allows a modular installation according to the distribution of the cable on the surface.
It must be embedded in concrete or cement, either in a layer of self-levelling cement or in the same flexible cement glue used to fix the ceramic floor.
Download the data sheet
- HEATING MAT
The heating cable itself is pre-installed in a fibreglass mesh with a defined spacing pitch and surface wattage.
It allows a much simpler and faster installation.
As with the heating cable, it is suitable for both renovation and new construction and the mat is embedded in a layer of cement.
It is the most widely used product range in new construction/complete renovations and in renovations under ceramic and marble floors.
We manufacture 10 different ranges covering a range of surface power from 60 to 180W/m2 and widths from 25 cm to 70 cm to respond to all kinds of different projects.
Download the data sheet
- HEATING FILM
Heating film is an ideal system for renovations. The film is installed without cement directly under a laminate floor. With a thickness of less than 1 mm, it is ideal for installation over an existing floor, raising the floor by less than 1 cm with the insulation included.
With surface powers from 60 to 200W/m2.
Parallel resistances allow to cut and connect directly on site.
Not suitable for installation in damp areas.
Download the data sheet
- ALUMINIUM MAT
Ideal for renovations. Dry installation without cement directly under the laminate floor. With a thickness of less than 2 mm, it is ideal for installation over an existing floor.
It has an aluminium layer on its entire surface connected to earth so that it can be installed in damp areas, complying with the requirements of the Low Voltage Regulations.
Available in two surface powers of 80 and 140 W/m2.
Download the data sheet